Use of localized necking and fracture as a failure criterion in ship collision analysis

This study explores the use of localized necking for failure modeling in maritime crash analysis, using large shell elements. The assumption that the failure of a large shell element occurs simultaneously with the onset of localized necking is revisited. This study particularly investigates the numerical implementation of the localized necking condition and its implications on the results of ship collision analysis involving not only plate rupture but also various failure mechanisms such as the crushing and tearing of web girders, stringers, and their intersections. Through a series of large-scale collision simulations, the effects of bending deformation on the initiation of necking, non-proportional loading paths, and ductile fractures not preceded by localized necking, are investigated. It is demonstrated that a localized necking-based fracture model provides a reasonable, relatively mesh-insensitive estimate of the onset of fracture in the outer hull panels; however, fracture propagation is very sensitive to the numerical implementation of the necking and fracture model, especially for the cases involving the crushing of web frames and stringers.     

UHPC薄板屈曲试验及临界板厚比研究

UHPC材料是一种新型纤维增强水泥基复合材料,利用材料强度高的特点设计建造桥梁通常为薄壁箱形结构,薄壁箱梁存在剪力滞效应、扭转畸变、翘曲失稳等问题。为研究UHPC箱梁顶板翘曲失稳,指导UHPC薄壁箱梁结构避免局部失稳破坏先于材料强度破坏,进行不同边界条件均布加载的19个UHPC薄板屈曲荷载试验研究。结果表明:UHPC板的屈曲主要有局部受压破坏、单方向裂缝破坏和双向裂缝破坏3种;屈曲荷载计算应引入材料和制作修正系数0.7;UHPC板最大幅值位于h/2高度,并只产生一个半波。最后对屈曲荷载试验值进行有限元计算分析对比,并通过欧拉公式推导UHPC箱梁顶板的临界板厚比限值。     

地铁隧道二次衬砌钢筋网防裂性能研究

为了定量分析防裂钢筋网提高隧道衬砌结构抗裂性能的机理和幅度,以地铁双线隧道二次衬砌结构为研究对象,采用荷载结构法和杆系有限元数值模拟方案,定量分析二次衬砌结构不设置与设置钢筋网这2种情况下的开裂临界荷载。其中素混凝土结构以达到极限拉应变为临界状态,衬砌结构增设钢筋网后以达到GB 50157-2013《地铁设计规范》允许的最大裂缝宽度0.2mm为临界状态。分析结果表明,配置防裂钢筋网后,Ⅲ级和Ⅳ级围岩衬砌结构抗裂性能可分别提高22.4%和19.3%,Ⅴ级围岩衬砌结构抗裂性能提高15.2%;Ⅲ级和Ⅳ级围岩二次衬砌结构的破坏形式由脆性破坏变为延性破坏,从而提高了其安全性能。     

Short-term statistics of ice loads on ship bow frames in floe ice fields: Full-scale measurements in the Antarctic ocean

Ship operation and ice loading in floe ice fields have received considerable interest during recent years. There have been several numerical simulators developed by different institutes which can simulate ship navigation through floe ice fields and estimate ship performance and local ice loads. However, public data obtained from full-scale measurement covering comprehensively ship performance and ice loads under various ice thicknesses, concentrations and floe sizes are rare. The 2018/19 Antarctic voyage of the Polar Supply and Research Vessel (PSRV) S.A. Agulhas II gathered considerable data of the ship in floe ice fields under various thicknesses, concentrations, and floe sizes. The aim of this paper is to carry out statistical analysis to seek suitable probability distributions which adequately fit the measured ice load and therefore suitable to be used as parent distributions for long-term estimation. For this aim, three categories of probability distributions, namely standard distributions, truncated distributions and mixture distributions are tested. It is found that truncated distributions can fit the load data better than standard distributions bounded at the threshold. In addition, mixture distributions are shown to have promising features, which fit the data well and are able to separate distribution components. Subsequentially, the well-performed distributions are used as parent distributions to make long-term load estimations. The estimation results demonstrate that long-term estimations are sensitive to the selection of parent distribution, which addresses the importance of finding correct distribution to model short-term ice loads. The data of ten selected cases will be published for the use of other researchers.     

25t轴重荷载作用下隧底脱空区域受力特性分析

为了研究在役铁路隧道在通车之后隧底脱空病害的问题,采用有限元理论,建立隧道脱空区域在围岩压力与25 t轴重列车动载作用下的数值计算模型,主要研究80 cm与40 cm脱空宽度分别距隧道中心线0,80 cm与160 cm时脱空区域的受力特性。结果表明:在围岩压力下,脱空区域中线上壁和外侧顶角混凝土中产生拉应力及内侧顶角中产生压应力,其中压应力对脱空的宽度更为敏感;同时施加列车动载作用时,脱空区域上壁出现了竖向动应力与横向拉应力,得到了脱空区域力学指标的最大响应值及其出现的具体位置,宽度的增加对脱空区上壁横向拉应力更为显著,上壁横向拉应力增幅超过200%,竖向动应力增幅达50%。因此,隧底脱空区周围应力分布复杂,拉应力与压应力在脱空区域同时存在,应力突变严重,对脱空现象应及时组织处理。     

低周疲劳载荷下考虑累积塑性的船舶裂纹板剩余极限强度研究

研究表明在恶劣海洋环境中船体结构整体断裂破坏往往是低周疲劳破坏和累积塑性破坏的耦合结果。考虑这两者耦合作用的影响,评估船体结构的极限承载力更为实际。基于累积塑性和低周疲劳裂纹扩展,从理论上分析了平面内低周疲劳载荷下裂纹板的残余极限强度。经过一系列数值模拟,首先讨论低周疲劳裂纹扩展行为的影响,然后随着疲劳裂纹扩展的发展,主要讨论了初始变形,焊接残余应力,裂纹扩展长度,裂纹分布和裂纹板厚度对低周疲劳载荷下船体裂纹板极限强度的影响。     

船用水润滑艉轴承的润滑承载特性

船用水润滑艉轴承由于其节能环保、结构简单和维护便利等优点一直作为船舶推进系统的研究热点。本文主要总结了船用水润滑艉轴承润滑承载特性方面的内容，轴承的润滑承载性能主要通过偏心率、最小水膜厚度、水膜压强和摩擦系数等参数描述。分别说明了工况参数、结构参数、材料参数对轴承承载润滑特性参数的影响，分析了上述三个方面的参数对轴承承载润滑参数的影响规律。其中，工况参数包括负载、速度、温度等，结构参数包括间隙、长径比、轴承直径、导水槽结构等方面，材料参数主要为材料的弹性模量和泊松比等。本文可以对船舶水润滑艉轴承的研究工作提供参考。     

美标高桩码头抗震计算位移法的对比

从原理和适用性的角度对美标高桩码头抗震计算方法进行对比,着重研究了位移法及其中的替代结构法。对替代结构法中推覆曲线的双折线化方式、阻尼比计算、反应谱衰减等影响因素进行分析。通过推覆分析和替代结构法计算变形能力和地震位移、复核码头抗震性能。结合实际案例,采用反应谱法和替代结构法对某高桩码头结构进行抗震分析。结果表明反应谱法趋于保守,不能反映塑性后的荷载衰减,相比而言替代结构法更为准确。而对于替代结构法,不同的等效阻尼比会较大程度影响地震位移结果。     

基于有限元模型的船用螺旋桨桨叶应力分析

采用计算流体动力学(Computational Fluid Dynamics,CFD)软件建立静止域(舵、导管及船体)和旋转域(螺旋桨)的三维几何模型,在螺旋桨流场内求解雷诺平均纳维-斯托克斯方程(Reynolds-Averaged Navier-Stokes equations,RANS),由此对船用螺旋桨产生的推力和转矩特性进行数值模拟。对比分析在压载工况和满载工况下螺旋桨桨叶的压力分布、沿不同轴的受力情况和绕不同轴的转矩情况,为轴系弹性校中提供更加准确可靠的应力情况,对船用螺旋桨的生产设计提供有益的参考。     

中外岸坡抗强震设计方法对比

天然岸坡以及工程岸坡(如防波堤、驳岸、航道等)在众多海外项目中普遍存在,并往往因为强震作用而产生显著的位移变形。国内外技术规范以及参考指南针对这一问题,分别提出拟静力法、Newmark滑块位移法、时程位移分析法等设计方法。针对不同方法以及判别标准,依托海外某回填陆域工程的岸坡稳定及位移分析结论,分别采用滑弧稳定分析、地震位移经验公式以及时程位移分析,进行方案的综合分析论证。结果表明,中外不同分析方法的判别标准稍有差别,但均能较好地依托实际,在总体安全储备方面相符。